How to change the wind shield wiper blade?

It is a very simple and not a hurry as you may see here the step,

1. Place up the viper blade perpendicular to the wind screen of your car.
2. Open the behind pin used either a test pen to remove the wiper blade
3. certain car will mount it with screw and you must remove the screw before you take it out,
4. replace the new viper blade and put back the viper into the origin position

Recommended :You should choose the silicone wiper blade cause it hos more longer lasting and more smoother than the rubber material.

How to repair the surface dashboard?

Why is so importance to repair your dashboard? and isn't look ignoring to you when your old dashboard cracks?

It will goes even worst if we does not take care it and really ignoring when you look a big scar in your dashboard. Here i would like to share some tip with you , how are you going go to repair on your dashboard.

1. Use a utility knife to cut V shape on the cracks and be careful for not to much on the crack.
2. Clean the outer and the inner layer of the shape.
3. use a masking tape mask on the side of the crack on the dashboard.
4. Apply the caulking silicone onto the V-shape and allow it dried for 10 - 15 min before removing the tape. If the crack is too small then remove the tape for allowing the silicone to enter into the crack. If the crack to large then you may choose to texture the silicone using the texturizing portion of a vinyl repair kit.
5. use the similar color to your car and try to paint a big potion so that the crack are visible to seen.\

Equipment needed:

- utility knife
- masking tape
- silicone caulking
- paint same to the color with your dashboard.
*** img from.carthrottle.com  ***

How to replace engine mount?

An engine mounting made of rubber that is inserted between the engine and the the body frame. The mounting reduces vibrations between them.


Tips:

1.  Lift the front of vehicle using hydraulic car jack. Ensure the vehicle sit on the both jack stand.
2. Remove the covers that conceal on the  motor mounts from the bottom of the engine using a ratchet. Loosen the bolts connecting the motor mounts to the engine using a ratchet set. Raise the engine slightly using the jack .
3. Removing the bolt that securing the mount and pull out the insert mount. Insert back the new engine mount and replace the bolt that securing the mount using ratchet. Repeat for each different mount .
4. After complete that, lower down the to the frame and tighten the bolt with the specification given there.

Equipment needed:

- car jack
- ratchet set (make sure there have a specification for the ratchet set)
- a pair of stand

Material - New set of engine mounting